Honda Door Lock Actuator Screws Stuck

Car door lock actuators are designed to lock and unlock a door without the effort of pulling on a cable and rod.

Honda door lock actuator screws stuck.

Just unhook and slide through the holes on the metal. The latch assembly gets corroded and when the pull lever cannot return fully to the rest position the latch assembly will not operate. Observe the plastic tab above and beneath this screw. Take the inside door release lever panel off and push the lever rod all the way to the rear.

2007 honda cr v door lock actuator repair. Install the lock subassembly onto the new door lock actuator using the new screws from the kit p n 72116 swa a01 and p n 72116 swa 003. The 2010 honda cr v has 4 problems reported for door lock actuators failed. Remove the single screw in the middle of the gold plate taking care to note the position orientation of the small locking lever.

Remove this screw and unhook the tabs holding the black plastic housing for the actuator. A rod connects the actuator to the latch and another rod connects the latch to the knob that sticks up out of the top of the door. If you are having problems with your door locks this is the video for you make sure to watch until then. The lock actuator is behind this screw.

Using a screwdriver test that the locking mechanism works by locking the latch then checking if the door latch releases using the outer handle lever. There is many helpful tips and tricks to aid you in. Unclip the broken actuator from the locking assembly. In some cars the door lock actuator is positioned below the latch.