A failing door interlock is a very common cause of pcb failure.
Hotpoint aquarius wma50 door lock flashing.
The problem is with dirty or defective motor brushes that prevent the machine from starting so it unlocks the door.
I have tried a new door lock 15 groan and checked theres no water in tub or pump problem.
A quick solution is.
I have also checked the presure switch which seems to be fine also.
When the door closes the door catch should fit inside and operate something inside the door lock which activates the lock.
Door locked indicator is flashing hotpoint aquarius wma4 the origional door lock also appeared to function i e.
The fact that it is clicking shows that it is functioning.
Remove the rear panel of the machine take off the drive belt disconnect the white plug and earth lead from the motor.
Move the hotpoint aquarius washing machine to a more level surface or adjust the heights of the stabilising feet on the bottom of the unit.
Remove the washer s electrical plug wait for two minutes and reinsert the plug firmly in its socket if the washer isn t running.
Door light keeps flashing and washer will not start.
Hotpoint 1100 aquarius wma31.
If by any chance the door is properly closed but the door locked light is still flashing then there may be a fault on the door lock or somehow the door lock is not being properly activated when the door closes.
I have managed to manually release the door as there was washing in it.
Hotpoint aquarius wma58 flashing door lock light.
Any more information on repair replacement of the control board module would be appreciated.
In 99 of cases a flashing door locked light means that either the door latch spring the door interlock or the pcb itself is faulty.
Door lock light light 1 starts flashing and it clicks 6 times.
I am now at a loss any thoughts will be would be a great help.
I replaced it only because the door locked light was flashing.
