How Do I Fix A Broken Closet Sliding Door

If a roller is stuck unscrew and remove it.

How do i fix a broken closet sliding door.

Chances are it s out of alignment in the door frame. Sliding closet doors are loose and swing in and out. If your doors hang from a top rail and do not have a track on the floor then you need to either replace or tighten down the floor guides. Remove a door by lifting and tilting the bottom out.

If you have a sliding closet door that glides on a bottom track clean the track with a damp cloth to ensure smooth gliding. It will probably be easier to simply have the broken mirror replaced. Lubricate the rollers but not the track because lubricant will act as a magnet for dust. Shop around and get a few quotes and explore your options.

Sliding bypass doors hang from rollers that glide on a track hidden inside the top jamb of the door frame. If a malfunctioning sliding door is a chronic problem see if the track is dirty. Compare cost of replacement of glass with cost of door replacement. Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws.

Does it need to be repaired. The door edge and frame should line up nice and parallel. Raise it just enough to clear the track and roll smoothly. Then just pull it carefully forward and it should come out of the track on the bottom.

Built up dirt or loose debris can cause a door to stop sliding and ride off the track. When you do this the bottom wheels that were sticking in the track should pop out. The closet doors must be taken off before you can replace the broken track. Use a wire brush to clean off the dirt or debris.

Watch my video to see the steps i took to fix an internal sliding do. In order to do this take hold of the edges of the door and pull it up. Even if it s off by only 1 4 in the door will probably bind. Use the blade of an old screwdriver to pry stubborn dirt loose.

To start your sliding glass door adjustment project first lift or lower the door on the track with a screwdriver or allen wrench. Bifold doors consist of two pairs of hinged panels that pivot on a pair of pins. A plastic guide attached to the floor typically keeps the door in place. How to clean or fix a door track.

First close the door and look along the edge of the door as it lines up with the frame opening photo. The fix is usually simple and often takes less than 10 minutes.