How To Attach Bathroom Sink To Wall

Measure and mark the location of the sink on the wall again.

How to attach bathroom sink to wall.

Two on the rear against the wall and one on each side. Loosen the slip nut at the top of the p trap. Mount the sink to the wall. Be sure to use a masonry.

The valves are typically under the sink. Lift the back edge of the sink onto the bracket. The standard cast iron brackets available for vintage sinks do not seem designed for this sink s brackets. Use your hands or locking pliers to unscrew the nut.

Install the sink if your sink includes a mounting plate you can use that for a template to drill your pilot holes. Use the template that comes with the sink to mark the. Set the sink on top of the pedestal then slide the sink close enough to the wall so you can insert the winged toggles into the mounting holes in the wall. Drill your pilot holes for the lag screws which should be included with your wall mount sink.

This metal or plastic nut will be located either in the wall or the floor. Follow manufacturer s directions for the size and depth of. If there are large gaps at the wall or floor attach quarter round moulding along the wall or floor edge. Have a small bucket ready to catch any water.

Locate the large nut that connects the sink to the drain and disconnect it. Attach the sink 1. Check the level again before trimming the shims with a utility knife. If not turn off the water at the main valve.

Turn off the water supply. Then turn on the faucet. Installing a bathroom sink in a vanity is made easier by the fact that the supply lines and the drain all remain hidden within a cabinet. Remove the entire trap if necessary.

The pockets are not deep enough for the tabs on my sink the holes do not align etc. If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain. Attach the vanity to the wall using 3 inch drywall screws. Lift the sink slightly while tightening the nuts with a wrench.

For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink. Use plumber s putty as you attach the. Ideally i would like to mount the sink using only the two rear tabs bolted to the wall. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers.

Prepare the faucet drain and pop up. Drill pilot holes into the wall at the marked locations. Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it.