How To Attach Rope Lights To Garage Door

Place the tape directly on the center of the truss.

How to attach rope lights to garage door.

Wrap the strand along one side and across the top if long enough until it is taut. Rolls and cut it on the job. It s a flexible solid plastic rod with a series of tiny bulbs embedded in it. Install a cable connector into a hole on the motor housing.

Calculate the total length needed add 10 percent and buy one long piece it s available in 250 ft. Start the first light strand at the bottom corner of either a window or door and work upward. Insert the cable end far enough for the wires to reach the terminal board. Rope lighting is unique.

Remove the cable s outer jacket and strip the insulation from. This video describes how to set up a warning light inside your house to inform you that your garage door has been left open. Vinyl mounting blocks are available for almost any lap and securely hold lights upright. All we used was pvc piping and no hole hangers.

Grab a ladder and roll the tape along the bottom of the truss. I used a small roller to securely press the tape onto the truss. Basically what you need to do is attach the outlet feed wires to the back of the garage light switch to estabilish a passthrough circuit. Only roll out as much as you can reach so that the roll doesn t fall to the ground and get dirty.

You can find various types at a hardware or home improvement store. This is one way to install christmas lights around a garage door with out damaging your home. Create a rock solid base for exterior light fixtures mounted on vinyl or aluminum lap siding without removing any siding. To avoid damaging your lights and creating a fire hazard at the same time use clips or hooks to hang your lights from your garage.

Don t use staples nails or a hot glue gun to hang your lights. Many attach securely and safely to shingles or gutters.