Scratch and brown coat in a three coat stucco application.
How to brown coat stucco on rough concrete wall.
This mix is the perfect base coat choice for a traditional three coat stucco application.
Parex usa mesh embedded in stucco level coat 10.
The finish coat is not considered a step because it is needed on every type of application that is used so they are mainly referring to the stages up until the.
Stucco installation labor basic basic labor to install stucco with favorable site conditions.
This will form the bonding between the topcoat and the anchoring of the scratch coat.
Stucco can be applied to wood sheathed walls in typical frame construction by adding a metal lath over the wood.
And 3 1 2 to 5 parts sand.
Parex usa weather seal 5.
Meets astm c926 requirements for portland cement based plaster.
Apply directly to masonry walls in a two coat stucco application.
Parex usa 100 or 300 series brown coat 9.
1 part hydrated lime.
Use the flat finishing trowel to spread the stucco evenly across the surface.
Some masons skip over this step but it doesn t hurt to spend the time for this process.
Can be applied with a trowel or sprayer according to typical stucco techniques.
A stucco wall must be supported by some load bearing material such as wood or concrete.
Stucco can be applied directly to any masonry based wall such as brick concrete or cinder block.
This first coat is known as the scratch coat this coat helps the final coat bond properly to the wall.
Notice the mix has more sand.
1 part portland cement.
Base coat stucco can also be applied directly to masonry walls for a two coat application.
Install building paper metal lathe and three coat scratch brown and finish stucco.
In industry terms lath scratch and brown.
Use for scratch coat stucco and brown coat stucco applications.
Shea thing tape 4.
Finish parex usa watermaster krak shield he 1.
Parex usa 100 or 300 series scratch coat 8.
Apply the first coat of stucco to the concrete surface.
Three coat is the original stucco process consisting of paper and wire a scratch coat a brown coat and a finish or top coat.
After the cement is on the wall a scratcher is used to make horizontal lines in the stucco mix in order for the next coat the brown coat to stick to it.
This acts as an ideal base for the finish coat which is integrally colored in most cases and is what you see on stucco so the base needs to be uniform.
Allow the scratch coat to harden slightly.
For the brown coat you will need.
It s usually finished in a rough texture.
The scratch coat should be between 1 4 and 1 2 inch thick.
Includes planning equipment and material acquisition area preparation and protection setup and cleanup.
The brown coat surface is much smoother than the scratch coat and is gritty to the touch but flatter and looks more appealing than the scratch.
