How To Change A Garage Door Opener Motor

Please subscribe to my new channel handy homeowner dedicated to how to videos like this one.

How to change a garage door opener motor.

How to repair a garage door opener motor. Make sure that the unit s power is. Use the open ended adjustable wrench to loosen the bracket and remove the bracket on the door and the bracket above the. Remove the fastener ring from the straight door arm connected to the outer trolley.

Press and hold the down button until the door is in the desired down position toggling the up and down buttons as necessary to achieve the desired down position. Add the stop switches to the rail that turn the garage door opener off one approximately 12 to 14 inches from the motor and the other the same distance from the end of the rail. Position a work table near the area under your motor unit to hold the garage door opener during the repair. Buying the replacement kit purchase the replacement kit depending on whether or not you are replacing the motor.

Press and release the black adjustment button. Realignment of the electric. Pull the emergency release rope to release the trolley from the garage door. Turn the power off to the garage at the circuit panel.

Shut the garage door if it s not already closed. Spray the sides of the garage. The garage door opener lights will flash twice to indicate that the up position is set and the down button then flash. Before you start inspecting the motor make sure the garage door is fully functioning.

Loosen the brackets securing it to the ceiling and gently lower it down. Buying the replacement kit step 1.