How To Change Lock In A Door

Position the lock mechanism such that the keyhole is vertically aligned.

How to change lock in a door.

Insert a flatheaded screwdriver into the spindle housing hole. If your new lock is the same brand and model as the old one you may be able to keep your existing latch plate and strike plate. How to change a upvc door lock. Once the new pins are in reverse the steps to reassemble the lock.

When the screws are out both sides of the lock will simply slide off leaving only the latch in the door. Insert another flathead screwdriver under the edges of the tabs holding the lock cylinder in place within the housing. In most cases you can use your fingers in the hole left by the lock to remove the lock s latch through the side of the door. Insert the new bolt into the opening on the edge of the door and fasten it to the door with the provided screws.

On the opposite side insert the bar into the channel in the back of the turn assembly plate. Remove the screws from the old lock on the inside of the door. Insert the bar protruding from the new deadbolt lock through the channel in the deadbolt itself. Use a phillips head screwdriver to unfasten the two or three screws located on the inside knob plate.

Remove the latch assembly doorknob. Then remove each side s door knob by pulling them away from the door. Rekeying involves realigning the pins and springs in the inner workings of the lock in. Remove the strike plate on the door jamb as well.

Remove the two screws from the latch assembly on the side of the door. You may also need to use a wire tool or a paper clip. Insert the exterior part of the lock into the door by feeding the long metal piece through the opening in the center of the bolt. Insert the pins and reassemble the lock dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to the color code on the special instruction sheet.