How To Change The Door Lock Sequence On A Toyota

Remove the door panel by removing a screw in the arm rest and in front of the door handle.

How to change the door lock sequence on a toyota.

Shift the shift lever to p or n and press and hold the driver s door lock switch for approximately 5 seconds and then release. Step 3 press and hold down lock one for about five seconds to disable automatic locking function when transmission is pulled out of park step 4. Peel back the shroud covering the interior components. Shift the transmission into park or neutral and use the driver s side lock keys one or two for different functions.

Change the position to door make sure all the doors are shut and that your shift lever is set to park put the key in the ignition and turn it so it is set to on once you are in the on position and before 5 seconds has passed push down the door lock switch on the driver s side keeping it down for 5 seconds. While removing the door panel unhook the electronic connection to the power door lock mechanism on the door panel. Toyota door lock repair. All toyota vehicles with an automatic transmission and power door locking system have a feature that allows the driver to select an automatic locking and unlocking sequence for the doors.

Use the same procedure to cancel the function. Do it yourself repair shows door panel removal and then removing lock actuator. Locate the door actuator and removing it. The dome light will flash to indicate the mode that is active.

One flash indicates mode 1 two flashes mode 2 three flashes mode 3 and four flashes mode 4. I had these and other settings including opening the windows from the keyless remote door lock after 10mph door stays locked when shifted to park windows open close with key in door disabled seatbelt chime i carry weight in the pass. The shift lever and switch positions corresponding to the desired function to be set are shown in the following table.